This is the registration page for Trisys, Inc software.

The instructions below will guide you in collecting the necessary information to submit for your registration. Once online part of registration is completed, you will be emailed a registration number. This number is required to complete the registration process on the PC where Trisys Software is installed.
Note: Trisys software must be registered, otherwise it will stop working 30 days from the time of installation.

Please print this page and follow the steps below to register your software.

BEFORE YOU CONTINUE:
If you need to change your old serial number to a newly obtained one, replace the old serial number on the PC where TAPIT is installed before proceeding with the new registration. You can change serial numbers using TAPIT Setup located under Start->Programs->Tapit->Tapit Setup.
Only after the new serial number is in effect, you can proceed with the registration.

Step 1. - On the machine running Tapit click on Start, Programs, Tapit , and Register Tapit

Step 2. - Record the Serial No.

                and Computer ID

Step 3. - Print this page if not already done. Then click HERE TO START REGISTRATION

Step 4. - Enter the numbers that were recorded in the form provided and click Continue

Step 5.Complete the form with requested information. Please note, the registration number will be sent to the email address entered here. Click Register

Step 6. - The confirmation page appears. The registration number has been emailed to the address specified in step 5.

Step 7. - Return to the Register screen and enter Registration Number (received via email) into the appropriate spaces and then click Apply. You will receive confirmation 'This software is registered properly'. Click OK and then close Tapit Register.

Registration is now complete. Thank you for using Trisys, Inc. software.